SIMPLE SOLUTIONS

.ISDNCTRL_CONF(8) - Linux man page online | Administration and privileged commands

Writes the configuration into a file. If is omitted, the default file will be used. Reads the configuration from a file. If is omitted, the default file will be used. This syntax will be used for the options and All entries are included in the section This section contains an entry which describes the interfaces. Each subsection describes one interface. There are the following entries possible: The name of the interface. This entry is required. NAME = ippp0 Set the EAZ or the MSN. This entry is required. EAZ = 4711 Set the incoming phone number(s). It requires at least one blank between the different numbers. PHONE_IN = 08151234 08151235 08151236 Set the outgoing phone num‐ ber(s). It requires at least one blank between the different numbers. PHONE_OUT = 08151237 08151238 Turn on or off the security fea‐ ture. SECURE = on Selects callback mode. CALLBACK = in Turns on or off hangup before starting callback. CBHUP = on Set the callback delay to CBDELAY = 5 Set the number of dial atempts to DIALMAX = 1 Set the hanguptime to HUPTIMEOUT = 20 Turns on or off the hangup timeout for incoming calls. IHUP = on Turns on or off hangup before next charge info. CHARGEHUP = on Sets the charge interval to CHARGEINT = 1 Set the layer‐2 protocol. Allowed values for L2_PROT = hdlc Set the layer‐3 protocol. Allowed value for L3_PROT = trans Sets the encapsulation mode. Allowed values for ENCAP = rawip Adds a slave interface for channel‐bundling. ADDSLAVE = s‐ippp0 Set the delay in seconds for the slave‐dial‐ ing. SDELAY = 10 Set trigger level for slave‐dialing. TRIGGER = 4000 Binds the current interface to a specific physical channel. Before and after the comma may not be a blank. BIND = teles1,0 Binds the current interface to the ippp device This works only for synchronous ppp. The value must be a number. PPPBIND = 0 [ISDNCTRL] INTERFACES = { [INTERFACE] NAME = isdn0 EAZ = 4711 PHONE_IN = 08151234 PHONE_OUT = 08151234 SECURE = on DIALMAX = 1 HUPTIMEOUT= 20 IHUP = on CHARGEHUP = on L2_PROT = hdlc L3_PROT = trans ENCAP = rawip ADDSLAVE = s‐isdn0 SDELAY = 10 [SLAVE] NAME = s‐isdn0 EAZ = 4711 PHONE_OUT = 08151234 SECURE = on DIALMAX = 1 HUPTIMEOUT= 10 IHUP = on CHARGEHUP = on L2_PROT = hdlc L3_PROT = trans ENCAP = rawip [INTERFACE] NAME = ippp0 EAZ = 4712 PHONE_OUT = 08151235 08151236 SECURE = on DIALMAX = 5 HUPTIMEOUT= 200 IHUP = on CHARGEHUP = on L2_PROT = hdlc L3_PROT = trans ENCAP = syncppp PPPBIND = 0 }
Download raw manual
Main page № 8 (+5755)
Go top