ADD_TXRX(1) - Linux man page online | User commands

Add two new Data Sources called 'tx' and 'rx' to an RRD file.

ADD_TXRX(1) General Commands Manual ADD_TXRX(1)


add_txrx - add two new Data Sources called 'tx' and 'rx' to an RRD file


add_txrx <file> ...


This utility is used when upgrading from FlowScan-1.005 (or less) to FlowScan-1.006 (or greater). It is used to add two new Data Sources to FlowScan ".rrd" files. e.g.: $ make install # install FlowScan-1.006 in your existing FlowScan dir $ cd $prefix/graphs $ add_txrx total.rrd *.*.*.*_*.rrd tx - a count of the unique source IP addresses that have transmitted flows rx - a count of the unique destination IP addresses that have received flows These Data Sources will allows FlowScan users to calculate the average number of bytes, packets, and flows per host and to determine the overall level of activity (in terms of numbers of individual hosts) for each subnet and for the entire campus. The values will be recorded only if you use the TopN directive with the CampusIO and/or SubNetIO reports. TopN was introduced in FlowScan-1.006. For instance, if you set CampusIO's TopN to a value greater than zero, the tx value in FlowScan's "total.rrd" is the number of unique source IP addresses (hosts) from which FlowScan has seen outbound flows. Upgrading your RRD Files If you are upgrading, it is necessary to add two new Data Sources to the some of your existing RRD files. Before running flowscan, backup your RRD files, e.g.: $ cd $prefix/graphs $ tar cf saved_rrd_files.tar *.rrd then do this: $ cd $prefix/graphs $ ../bin/add_txrx total.rrd [1-9]*.*.*.*_*.rrd

SEE ALSO, event2vrule(1), flowscan(1), ip2hostname(1), locker(1)


This manual page was written by Anibal Monsalve Salazar, for the Debian Project.
This manual Reference Other manuals
add_txrx(1) referred by | event2vrule(1) | flowscan(1) | ip2hostname(1) | locker(1)
refer to | event2vrule(1) | flowscan(1) | ip2hostname(1) | locker(1)
Download raw manual
Index General Commands Manual (+12866) № 1 (+39907)
Go top