AMTAPE(8) - Linux man page online | Administration and privileged commands
Control Amanda changers.
AMTAPE(8) System Administration Commands AMTAPE(8)
Amanda 3.5.1 12/01/2017 AMTAPE(8)
NAMEamtape - Control Amanda changers
SYNOPSISamtape [-o configoption...] config subcommand [subcommand_options...]
DESCRIPTIONAmtape is the command-line interface to Amanda's tape changers (amanda-changers(7)) and to the taperscan algorithm (amanda-taperscan(7)). Tape changers maintain a notion of the current slot for each configuration. This may or may not correspond to an actual physical state of the device, but is used by some taperscan algorithms to minimize searching through the slots. Amtape uses the default changer. To use a different changer, use the config override option, e.g., -otpchanger=otherchanger.
SUBCOMMANDScreate Call the changer create method, it create the vtape root dirtectory or the s3 bucket. label label Search for and load the Amanda tape with label [label], also setting the current slot. slot slot [drive drive] Load the volume in the given slot, also setting the current slot. The slot names current, next, first, and last have special meaning. current Shorthand for slotcurrent. inventory Show the contents of all slots, based on the changer's cached metadata. This is a quick operation as it does not load or unload any volumes, but is not supported by all changers. show [slots] Show the contents of all slots (or listed slots) by loading each slot and reading its label. This can be very slow. The slots arguments is of the form 1,3-5,7. reset Reset the changer to a known state. This subcommand is intended to clear any unknown and potentially incorrect state the changer may have stored. eject [drive] Eject the tape currently in the drive. This only applies to some changers. Specify a drive (by drive number) if more than one drive is available. clean [drive] If a cleaning tape is defined for the changer, used it to clean the specified drive. The [drive] is optional if the changer only has one drive. sync-catalog sync the catalog with a device that support it, taper Run the taperscan algorithm (see amanda-taperscan(7)), displaying information about the progress of the scan. update [what] Update changer state. Consult amanda-changers(7) for changer-specific details on the format of what. verify Verify the changer is correctly configured. Can be useful for chg-robot and chg-ndmp. -o configoption See the "CONFIGURATION OVERRIDE" section in amanda(8).
SEE ALSOamanda(8), amanda-changers(7), amanda-taperscan(7), amanda-devices(7) The Amanda Wiki: : http://wiki.zmanda.com/
AUTHORSDustin J. Mitchell <@zmanda.com> Zmanda, Inc. (http://www.zmanda.com) James da Silva <@amanda.org> Stefan G. Weichinger <@amanda.org>
|This manual||Reference||Other manuals|
|amtape(8)||referred by||amanda(8) | amanda-changers(7)|
|refer to||amanda(8) | amanda-changers(7) | amanda-devices(7) | amanda-taperscan(7)|