SIMPLE SOLUTIONS

FIREQOS-INTERFACE(5) - Linux man page online | File formats

Create an interface definition.

Chapter
Built 04 Nov 2017
fireqos-interface(5) 3.1.5 fireqos-interface(5)

NAME

fireqos-interface - create an interface definition

SYNOPSIS

{ interface | interface4 } device name direction [optional-class-params] { rate | commit | min } speed interface46 ... interface6 ...

DESCRIPTION

Writing interface or interface4 applies traffic shaping rules only to IPv4 traffic. Writing interface6 applies traffic shaping rules only to IPv6 traffic. Writing interface46 applies traffic shaping rules to both IPv4 and IPv6 traffic. The actual traffic shaping behaviour of a class is defined by adding classes. See fire‐ qos-class(5). Note To achieve best results with incoming traffic shaping, you should not use 100% of the available bandwidth at the interface level. If you use all there is, at 100% utilisation of the link, the neighbour routers will start queuing packets. This will destroy prioritisation. Try 85% or 90% in‐ stead.

PARAMETERS

device This is the interface name as shown by ip link show (e.g. eth0, ppp1, etc.) name This is a single-word name for this interface and is used for retrieving status in‐ formation later. direction If set to input, traffic coming in to the interface is shaped. If set to output, traffic going out via the interface is shaped. if set to bidirectional traffic for both input and output can be shaped. If you need to differentiate input and output parameters per statements within the inter‐ face, you can prefix them with input or output like this: interface eth0 lan bidirectional ... class voip input commit 1Mbit output commit 2Mbit ... optional-class-params For a list of optional class parameters which can be applied to an interface, see fireqos-params-class(5). speed For an interface, the committed speed must be specified with the rate option. The speed can be expressed in any of the units described in fireqos.conf(5).

EXAMPLES

To create an input policy on eth0, capable of delivering up to 1Gbit of traffic: interface eth0 lan-in input rate 1Gbit

SEE ALSO

· fireqos.conf(5) - FireQOS configuration file · fireqos-class(5) - QOS class definition · fireqos-params-class(5) - QOS class parameters · FireHOL Website (http://firehol.org/) · FireQOS Online PDF Manual (http://firehol.org/fireqos-manual.pdf) · FireQOS Online Documentation (http://firehol.org/documentation/)

AUTHORS

FireHOL Team.
FireQOS Reference Built 04 Nov 2017 fireqos-interface(5)
This manual Reference Other manuals
fireqos-interface(5) referred by fireqos-class(5) | fireqos-conf(5) | fireqos-match(5) | fireqos-params-class(5)
refer to fireqos-class(5) | fireqos-conf(5) | fireqos-params-class(5)
Download raw manual
Main page 3.1.5 (+194) FireQOS Reference (+75) № 5 (+2141)
Go top