TARG(4FREEBSD) - Linux man page online | Special files

SCSI target emulator driver.

December 13, 2011
TARG(4) BSD Kernel Interfaces Manual TARG(4)


targ — SCSI target emulator driver


To compile this driver into the kernel, place the following line in your kernel configura‐ tion file: device targ


The targ driver provides an interface for usermode programs to emulate SCSI target devices. A sample program that emulates a disk drive (similar to da(4)) can be found in /usr/share/examples/scsi_target. The targ driver supplies the control device /dev/targ. After opening the device, the file descriptor must be bound to a specific bus/target/LUN and enabled to process CCBs using the TARGIOCENABLE ioctl. The process then uses write(2) to send CCBs to the SIM and poll(2) or kqueue(2) to see if responses are ready. Pointers to completed CCBs are returned via read(2). Any data transfers requested by the user CCBs are done via zero-copy IO.


The following ioctl(2) calls are defined in the header file <cam/scsi/scsi_targetio.h>. TARGIOCENABLE (struct ioc_enable_lun) Enable target mode on the LUN specified by the fol‐ lowing structure: struct ioc_enable_lun { path_id_t path_id; target_id_t target_id; lun_id_t lun_id; int grp6_len; int grp7_len; }; The selected path (bus), target, and LUN must not already be in use or EADDRINUSE is returned. If grp6_len or grp7_len are non-zero, reception of vendor-specific commands is enabled. TARGIOCDISABLE Disable target mode and abort all pending CCBs. The CCBs may optionally be read as they complete. TARGIOCENABLE can then be called to activate a dif‐ ferent LUN. Multiple disable calls have no effect. The close(2) system call automatically disables target mode if enabled. TARGIOCDEBUG (int) Enables CAM_PERIPH debugging if the argument is non-zero, otherwise disables it.


<cam/scsi/scsi_targetio.h> describes the usermode interface. /sys/cam/scsi/scsi_target.c is the driver source file. /dev/targ is the control device.


/usr/share/examples/scsi_target, ahc(4), isp(4), scsi(4) FreeBSD Target Information,


The targ driver first appeared in FreeBSD 3.0 and was written by Justin T. Gibbs. It was rewritten for FreeBSD 5.0 by Nate Lawson <>.


Currently, only the ahc(4) and isp(4) drivers fully support target mode. The ahc(4) driver does not support tagged queuing in target mode.
BSD December 13, 2011 BSD
This manual Reference Other manuals
targ(4freebsd) referred by mpr(4freebsd) | mps(4freebsd) | mpt(4freebsd) | sbp_targ(4freebsd)
refer to ahc(4freebsd) | close(2) | da(4freebsd) | ioctl(2) | isp(4freebsd) | kqueue(2) | poll(2) | read(2) | write(2)
Download raw manual
Main page BSD Kernel Interfaces Manual (+773) BSD (+3984) № 4 (+981)
Go top