IF_CDCE(4FREEBSD) - Linux man page online | Special files
USB Communication Device Class Ethernet driver.
November 24, 2015
CDCE(4) BSD Kernel Interfaces Manual CDCE(4)
BSD November 24, 2015 BSD
NAMEcdce — USB Communication Device Class Ethernet driver
SYNOPSISTo compile this driver into the kernel, place the following lines in your kernel configura‐ tion file: device uhci device ohci device usb device miibus device uether device cdce Alternatively, to load the driver as a module at boot time, place the following line in loader.conf(5): if_cdce_load="YES"
DESCRIPTIONThe cdce driver provides support for USB Host-to-Host (aka USB-to-USB) and USB-to-Ethernet bridges based on the USB Communication Device Class (CDC) and Ethernet subclass. The USB bridge appears as a regular network interface on both sides, transporting Ethernet frames. For more information on configuring this device, see ifconfig(8). USB 1.x bridges support speeds of up to 12Mbps, and USB 2.0 speeds of up to 480Mbps. Packets are received and transmitted over separate USB bulk transfer endpoints. The cdce driver does not support different media types or options.
HARDWAREThe following devices are supported by the cdce driver: · Prolific PL-2501 Host-to-Host Bridge Controller · Sharp Zaurus PDA · Terayon TJ-715 DOCSIS Cable Modem
DIAGNOSTICScdce%d: no union descriptor The driver could not fetch an interface descriptor from the USB device. For a manually added USB vendor/product, the CDCE_NO_UNION flag can be tried to work around the missing descriptor. cdce%d: no data interface cdce%d: could not read endpoint descriptor cdce%d: unexpected endpoint cdce%d: could not find data bulk in/out For a manually added USB vendor/product, these errors indicate that the bridge is not compatible with the driver. cdce%d: watchdog timeout A packet was queued for transmission and a transmit command was issued, however the device failed to acknowledge the transmission before a timeout expired. cdce%d: no memory for rx list -- packet dropped! Memory allocation through MGETHDR or MCLGET failed, the system is running low on mbufs. cdce%d: abort/close rx/tx pipe failed cdce%d: rx/tx list init failed cdce%d: open rx/tx pipe failed cdce%d: usb error on rx/tx
SEE ALSOarp(4), intro(4), ipheth(4), netintro(4), urndis(4), usb(4), ifconfig(8) Universal Serial Bus Class Definitions for Communication Devices, http://www.usb.org/developers/devclass_docs/usbcdc11.pdf. Data sheet Prolific PL-2501 Host-to-Host Bridge/Network Controller, http://tech.prolific.com.tw/visitor/fcabdl.asp?fid=20679530.
HISTORYThe cdce device driver first appeared in OpenBSD 3.6, NetBSD 3.0 and FreeBSD 6.0.
AUTHORSThe cdce driver was written by Craig Boston <@tobuj.gank.org> based on the aue(4) driver written by Bill Paul <@windriver.com> and ported to OpenBSD by Daniel Hartmeier <@openbsd.org>.
CAVEATSMany USB devices notoriously fail to report their class and interfaces correctly. Unde‐ tected products might work flawlessly when their vendor and product IDs are added to the driver manually.
|This manual||Reference||Other manuals|
|refer to||arp(4freebsd) | aue(4freebsd) | cdce(4freebsd) | ifconfig(8) | intro(4) | ipheth(4freebsd) | netintro(4freebsd) | urndis(4freebsd) | usb(4freebsd)|